Changing The Transaxle Fluid; Brake Maintenance; Checking The Parking Brake; Adjusting The Parking Brake - Toro Workman GTX Operator's Manual

Changing the Transaxle
Fluid
Service Interval: Every 100 hours
Every 800 hours/Yearly (whichever comes first)
Fluid Type: SAE 10W-30 (API service SJ or higher)
Fluid Capacity: 1.4 L (1.5 US qt)
1. Align a drain pan under the drain plug
49).
Figure 49
1. Drain plug
2. Remove the fill plug and the seal
Note:
Retain the fill plug and seal for installation
in step 6.
3. Remove the drain plug and the seal, and allow
the fluid to drain completely
Note:
Retain the drain plug and seal for
installation in step 4.
4. Install the drain plug and seal, and torque it to
20 to 27 N∙m (15 to 20 ft-lb).
5. Fill the transaxle with the specified fluid until it
runs out of the fill hole.
6. Install the fill plug and seal, and torque it to 20 to
27 N∙m (15 to 20 ft-lb).
(Figure
g034235
2. Fill plug
(Figure 49).
(Figure 49).

Brake Maintenance

Checking the Parking Brake

1. Engage the parking brake by pulling the
parking-brake lever toward you, until you feel
tension.
2. If you do not feel tension when pulling the
parking-brake toward you within 11.4 to 16.5 cm
(4-1/2 to 6-1/2 inches) from the "P" symbol on
the dash, then you need to adjust the parking
brake; refer to
(page 43).
Adjusting the Parking
Brake
1. Ensure that the parking brake is disengaged.
2. Using jack stands, lift the rear of the machine;
refer to Lifting the Machine (page
3. Using 2 wrenches, hold the adjusting post on the
caliper in place with 1 wrench, and loosen the
jam nut 1/4 turn with the other wrench
50).
1. Adjusting post
2. Jam nut
4. While holding the adjusting post and the jam
nut in place, turn the adjusting post in to tighten
(Figure 50).
Note:
Perform this step until you feel drag on
the wheel.
5. While holding the adjusting post and the jam nut
in place, back off 1/4 turn
6. While holding the adjusting post and the jam nut
in place, tighten the jam nut
7. Perform steps
43

Adjusting the Parking Brake

29).
Figure 50
3. Caliper
(Figure 50).
(Figure 50).
1 through 6 to the other side.
(Figure
g034434