Toro Workman GTX Operator's Manual page 40

with the slots in the headlight housing
42).
6. Secure lamp assembly by turning it 1/4 turn
clockwise (Figure
7. Connect the electrical connector for the harness
to the connector of the new lamp assembly
(Figure 42).
8. Connect the batteries and close the hood; refer
to Connecting the Batteries (page
Replacing the Headlight
1. Disconnect the batteries; refer to
the Batteries (page
2. Open the hood; refer to
(page 30).
3. Disconnect the electrical connector for the
harness from the connector of the lamp
assembly (Figure
1. Speed clip
2. Opening in the bumper
3. Adjustment screw
4. Remove the speed clips that secure the
headlight to the headlight bracket
Note:
Retain all parts for installation of the new
headlight.
5. Remove the headlight assembly by moving it
forward through the opening in the front bumper
(Figure 43).
6. Install the new headlight through the opening in
the bumper (Figure
42).
38).
Disconnecting
37).
Accessing the Hood
43).
Figure 43
4. Headlight
5. Lamp assembly
6. Harness-electrical
connector
(Figure
43).
Note:
(Figure
with the holes in the mounting bracket behind
the bumper.
7. Secure the headlight assembly with the speed
clips that you removed in step 4.
8. Connect the electrical connector for the harness
to the connector of the lamp assembly
43).
9. Adjust the headlights to direct the beams to
the desired position, refer to
Headlights (page
Adjusting the Headlights
Use the following procedure to adjust the headlight
beam position whenever a headlight assembly is
replaced or removed.
1. Turn the key switch to the O
on the headlights.
2. At the back of the headlight assembly, rotate
adjustment screws
headlight assembly and align the position of the
cast beam.
3. Connect the battery and close the hood; refer to
Connecting the Batteries (page
g035853
43).
40
Ensure the adjustment posts are lined up
40).
N
(Figure 43) to pivot the
(Figure
Adjusting the
position, and turn
38).