Toro Workman GTX Operator's Manual page 17

Key Switch
The key switch (Figure
off the machine, and has 2 positions: O
Rotate the key clockwise to the O
the machine. When the machine is stopped, rotate
the key counterclockwise to the O
off the machine. Remove the key whenever you leave
the machine.
Supervisor Speed-Limit Switch
The supervisor speed-limit switch, located under
the seat assembly, has 2 positions: P
and E . Rotate the switch clockwise to the
CONOMY
E position to limit the maximum machine
CONOMY
speed to 19 km/h (12 mph). Rotate the switch
counterclockwise to the P
restore the maximum speed of the machine to 26 km/h
(16 mph) as shown in
1. Performance position
2. Economy position
6), is used to run and shut
and O
N
position to operate
N
position to shut
FF
ERFORMANCE
position to
ERFORMANCE
Figure 9.
Figure 9
3. Supervisor speed-limit
switch
Status-Indicator Light
The status-indicator light is located to the right of the
. parking-brake lever on the control panel
FF
When the machine is turned on, the green
status-indicator light illuminates either solid or blinking.
If the light is solid, this indicates that the machine is
ready for normal operation. If the light is blinking,
there is an issue that needs to be resolved before
continuing with normal operation of the machine.
If the status-indicator light blinks 2 times, this
indicates that the parking brake is engaged while in
the F
ORWARD
selector. Disengage the parking brake to shut off the
status-indicator light.
Refer to Troubleshooting (page 48)
status-indicator light blinks more than 2 times.
Passenger Handholds
The passenger handholds are located on the outside
of each seat
g034167
1. Passenger handhold
17
or R position on the direction
EVERSE
(Figure 10).
Figure 10
Passenger Side Shown
(Figure 6).
if the
g033955