Adding Groups Using The Web Interface - Huawei TE20 Administrator's Manual

TE20 Videoconferencing Endpoint
Administrator Guide
Parameter
IP address
Left codec
number
Left codec
IP address
Right codec
number
Right codec
IP address
Screen type
Line 1 #1
Line 1 #2
Line 2 #1
Line 2 #2
Line 3 #1
Line 3 #2
Sort ID
Step 3 Click Save.
The settings take effect immediately. The new site is listed in the address book.
----End

6.2 Adding Groups Using the Web Interface

If certain sites regularly join the same conference, you can define these sites as a group on the
endpoint web interface.
Issue 01 (2016-09-01)
Description
addresses of the center, left, and right codec
participants. Numbers are assigned to
participants by a specific videoconferencing
service vendor and used by them to set up
calls.
NOTE
The Center codec IP address, Left codec IP address,
and Right codec IP address parameters are
unavailable for a Telepresence site whose Type is
E1 or 4E1.
This parameter is available only after
Category is set to CT site.
Set this parameter to Uni-screen or
Tri-screen.
Specify the numbers your endpoint uses to call
the site. These parameters are available only
for ISDN sites.

If the ISDN site rate is set to a value
ranging from 64 kbit/s to 2048 kbit/s, set
Line 1 #1 only, because you only need to
dial that number to call the site.

If the ISDN site rate is set to 2, 3, 4, 5, or 6
x 64 kbit/s, set the other required
parameters as well, because you need to
dial the BRI line numbers one by one to
call the site. For example, when the ISDN
site rate is set to 2 x 64 kbit/s, set the first
two parameters Line 1 #1 and Line 1 #2;
when the ISDN site rate is set to 3 x 64
kbit/s, set the first three parameters Line 1
#1, Line 1 #2, and Line 2 #1, and so forth.
Line 1 #2 specifies the second number of
the first BRI line.
Specifies the sequence number of the site in
the address book.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Address Book Management
Setting
The default value is
Tri-screen.
No default value is set for
this parameter.
The default value is 0.
59