Table of Contents
Advertisement
Installation Manual
Airbridge cBTS3612 CDMA Base Station
(1) Board label
(4) Anti-static bag
(7) Carton label
Figure 2-2 Carton packing and board packing package unpacking
Unpack the package in the following
1)
Check the label on the carton, the amount and type of boards in the carton in the
presence of the relevant people.
2)
Cut the strap with an angle pliers.
3)
Cut the adhesive tape along the gap of the cover of the carton box (great care
must be taken not to insert the knife too deep to avoid any damage on the
interior of the board).
4)
Unpack the carton and take out the foamed plate.
5)
Check the number of the board box to see whether it is the same as that marked
on the label of the carton, then take out the board box.
6)
Open the board box and take out the circuit board from the anti-static bag.
After unpacking of the box, there is still a layer of packing bag and an anti-static bag
around the board. Keep the boxes and anti-static bags for the possible future use, say,
for keeping spare board and for keeping the faulty board in times of repairing.
I. Checking the boards
Check the board and the software.
If the inner packing is damaged, it should be recorded in the report in detail. If the
inner packing is not damaged, engineer from the vender should take the main
(2) Foam plate
(5) Board package
(8) Packing tape
way:
2-11
Hardware Installation
2 Installation Preparations
(3) Board
(6) Pressure-sensitive adhesive tape
(9) Carton
Advertisement
Chapters
Table of Contents
