Installing The Valve Manifold Solenoid Harness - Toro TX 1000 Operator's Manual

7
Installing the Valve Manifold
Solenoid Harness
No Parts Required
Procedure
1. Remove the 4 bolts and washers securing the
manifold cover from the 4-in-1 bucket
25).
Figure 25
1. Manifold cover
2. Feed the solenoid connector end of the valve
manifold solenoid harness down the outer
protective sleeve of the 4-in-1 bucket hoses.
3. Remove the plugs from the valve manifold
terminals and install the solenoid connectors as
shown in Figure
(Figure
2. Bolt and washer (4)
26.
1. Valve manifold
2. Left and right solenoid
connectors
4. Tighten the centre screws on the solenoid
connectors securely.
g242611
15
Figure 26
3. Valve manifold solenoid
harness
g242609