Installing The 4-In-1 Bucket Lever - Toro TX 1000 Operator's Manual

6
Installing the 4-in-1 Bucket
Lever
No Parts Required
Procedure
1. Ensure that the rocker switches at the top of
the 4-in-1 bucket lever are at right angles to the
shaft opening as shown in
the handle locknut.
2. Remove the insert locknut
put the lever through the air deflector with the
opening facing forward and the lever shaft lead
and connector fed through the small drilled hole.
3. Install the locknut to the bottom of the lever and
thread the lever into the loader valve assembly.
Note:
Rotate the air deflector, lever, and lever
connector wire altogether to maintain the correct
orientation.
Figure 23
1. Rocker switch
2. Handle locknut
3. Shaft opening
4. With the shaft opening facing forward, secure
the lever from rotation and tighten the insert
locknut (18 mm) securely to the loader valve
assembly.
5. Loop the lever shaft lead clockwise around the
top of the loader valve assembly.
6. Connect the lever connector to the loader
arm/attachment lever connector beneath the
control panel (Figure
7. Push the air deflector below the control panel
and move the lever in all directions to ensure
that it slides freely.
Figure 23 and tighten
(Figure 23) and
4. Insert locknut
5. Lever shaft lead
10).
8. Attach the handle instructional decal onto the
bottom left corner of the control panel decal as
shown in
Note:
Clean and prepare the control panel
decal before installing the handle decal.
g242494
14
Figure 24.
Figure 24
g242493