Removing The Existing Lever - Toro TX 1000 Operator's Manual

6. Install the 5 A fuse into the inline fuse block on
the power lead branch.
5
Removing the Existing
Lever
No Parts Required
Procedure
1. Remove the retaining ring from the loader
arm/attachment tilt lever shaft and move the
washer up (Figure
2. Push up the air deflector from below the control
panel and slide it up the lever
Note:
You may need to adjust the position of
the lever to remove the air deflector.
3. Loosen the locknut (3/4 inch) at the base of the
lever (Figure 21).
Some parts not shown for clarity
4. Unscrew and remove the lever and air deflector
(Figure 21).
5. Modify the air deflector as shown in
20).
Figure 20
(Figure 20).
Figure 21
Figure
1. Drill a 5 mm diameter hole
for the lever connector
wire
2. Cut a 30 mm slot from the
centre of the drilled hole
3. 10 mm from the edge of
the existing hole to the
centre of the new hole
g242495
g242496
22.
13
Figure 22
4. Existing hole
5. Slots face toward lower
right side of control panel
g242427