Connecting The Loader Arm Branch - Toro TX 1000 Operator's Manual

Figure 6
1. Bulkhead coupler locknut
5. Remove the plug and connect the hose fitting
removed in step 2. Torque the fitting to 60 to 74
ft-lb (81 to 100 N·m).
6. Remove the grommet and plug nut from the rear
of the 7-pin connector, as well as the parts bag
inside the connector.
7. Install the 7-pin connector to the top of the
connector mount bracket with 2 bolts (5/32
inches), washers, and nuts
the nuts securely.
Figure 7
1. 7-pin connector
2. Bolt (washer and nut on
underside of bracket)
g242236
2. Connector mount bracket
(Figure 7). Tighten
g242253
3. Connector mount bracket
3
Connecting the Loader Arm
Branch
Parts needed for this procedure:
1 Relay and loader arm harness
1 Plug nut
Grommet
1 Wire harness retainer
2 Screw
Procedure
1. Loosen the captive screw (7/16 inch) on the
bottom right of the rear-access cover and open
it (Figure 8).
1. Captive screw
2. Along the top rail of the right loader arm, remove
the 2 screws, hose hold-down plates, and
spacer tubes (Figure
8
Figure 8
9).
g031217