Setup; Installing The Valve Lever; Checking Fluid Levels And Tire Pressure; Charging The Battery - Toro 22318 Operator's Manual

Setup

Installing the Valve Lever

1. Remove and discard the nut securing the bolt and lock
washer to the speed selector lever.
2. Secure the lever to the speed selector valve using the
bolt and lock washer as illustrated in
1. Speed selector valve lever 2. Speed selector valve
Checking Fluid Levels and Tire
Pressure
Before starting the engine for the first time, check the engine
oil and hydraulic fluid levels and the tire pressure. Refer to
(page ) and Changing the Hydraulic Fluid (page 29)
information.

Charging the Battery

WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Figure 4.
Figure 4
WARNING
Battery terminals or metal tools could short against
metal components, causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
• When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the traction unit.
• Do not allow metal tools to short between the
battery terminals and metal parts of the traction
unit.
1. Park the traction unit on a level surface, raise the loader
arms, and install the cylinder locks.
2. Stop the engine and remove the key.
3. Connect a charger to the battery
it for a minimum of 1 hour at 6 to 10 amps. Do not
overcharge the battery.
for more
1. Positive post
2. Negative post
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks
and flames away from battery.
4. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
11
(Figure
4
2
G003792
Figure 5
3. Charger red (+) wire
4. Charger black (—) wire
(Figure
5) and charge
3
1
5).