Table of Contents
Advertisement
1. Jam nuts
2. U-bolt
7.
Adjust the nuts
(Figure
rear of the cutting unit so that the tips of the rear
blades are 6 to 10 mm (1/4 to 3/8 inch) higher
than the front tips.
8.
Tighten the jam nuts.
6
Greasing the Cutting Unit
No Parts Required
Procedure
Before operating the cutting unit, it must be greased
to ensure proper lubricating characteristics; refer
to
Greasing the Bearings and Bushings (page
Failure to properly grease the machine will result in
premature failure of critical parts.
Figure 7
3. Height-of-cut chain
7) to raise or lower the
Product Overview
Specifications
Note:
Specifications and design are subject to
change without notice.
Width of
Cut
Height of
Cut
Net
Weight
g296783
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
16).
10
•
Model No. 31974: 1.52 m (60 inches)
•
Model No. 31975: 1.82 m (72 inches)
Adjustable from 25 to 152 mm (1 to 6 inches) in 13
mm (1/2 inch) increments
•
Model No. 31974: 195 kg (430 lb)
•
Model No. 31975: 222 kg (490 lb)
www.Toro.com
for a list of all
Advertisement
Table of Contents
