Table of Contents
Advertisement
4 To register the interlocked operation of the Lossnay unit and the indoor unit.
Use the [TEST RUN] buttons (shown as D) to register the relationship of the interlock between the Lossnay indicated in
•
"OA UNIT ADDRESS NO." and the indoor unit indicated in "INDOOR UNIT ADDRESS NO."
INDOOR UNIT
ADDRESS NO.
INDOOR UNIT
ADDRESS NO.
5 To return to the normal operation mode.
Press and hold down both the [FILTER] button (shown as A) and the "Louver" button (shown as B) at the same time.
•
This returns the unit to the normal operation mode. (OFF)
Note:
Be sure to set the indoor unit to the lowest address number in a group followed by the Lossnay unit. If this is not performed,
the Lossnay unit will not operate.
If there are multiple indoor units to be interlocked with the Lossnay unit, perform Steps 3 and 4 above for each of them.
15.3.4 Searching for interlocked registered units
6 Display the indoor unit address No. at "OA UNIT ADDRESS NO."
Press the "Operation mode" button (shown as G) and the following display will appear.
•
Press once again to return to "INDOOR UNIT ADDRESS NO." shown in Step 2.
7 Use the
and
Select the indoor unit address number to be confirmed.
8 Press the "Timer/continuous" button (shown as E). The display alternates between the two displays shown here.
192
OA UNIT ADDRESS NO.
(Alternation)
OA UNIT ADDRESS NO.
INDOOR UNIT
ADDRESS NO.
[TIMER SET] buttons (shown as H) to select the address of the indoor unit to be registered.
INDOOR UNIT
ADDRESS NO.
Address of the
registered unit
•
When registration has been completed suc-
cessfully, the display alternates between the
two displays shown in the figure.
•
If there is an error in the registration, "
will flash. This indicates the number of the
unit.
OA UNIT ADDRESS NO.
OA UNIT ADDRESS NO.
INDOOR UNIT
ADDRESS NO.
OA UNIT ADDRESS NO.
(Alternation)
INDOOR UNIT
ADDRESS NO.
OA UNIT ADDRESS NO.
"
Advertisement
Table of Contents
