Mitsubishi Electric Lossnay LGH-100RX3-CAN Technical Manual page 164

12.2 Connecting the power supply cable
LGH-50 and 100RX types
Control box cover
LGH-200RX type
Screw
LGH-50 and 100RX types
Grounding wire
TM1
Power supply cable
LGH-200RX type
TM1
Bush
Power supply cable
TM1
Grounding wire
Power supply cable
Cord clamp
Screw
Control box cover
PG connection
Power supply
cable
Cord clip
Transmission
cable
Bush
Insert the cutting
Control box
TB5
TM2
Transmission cable
TB5
TM2
Bush
Transmission cables
1. Remove the screws and open the control
box cover
2. Connecting the power supply cable and
transmission cable
Pass the power cable through the bush* and connect to the
TM1 terminal block using the round terminals. Connect the
grounding wire to the grounding terminal and secure tighten-
ing the bush. (*: for PG connection or the like)
CAUTION:
Always separate the power supply cable and transmission
cable by 5 cm or more to prevent malfunctioning of the unit.
If the length of the stripped power cables wires is too long,
the conductors may touch and cause shorting.
(1) Refer to the wiring diagram and screw down the grounding
wire and transmission cables to the terminal block.
(2) Secure the power supply cable and transmission cables
using the cord clamp.
Upon completion of the wiring connections, replace the control
box cover.
161