Related Manuals for Mitsubishi Electric Lossnay
Summary of Contents for Mitsubishi Electric Lossnay
-
Page 8: Operation
“NOT AVAILABLE” display flash and the fan speed does not change. This remote controller can not be used on Lossnay units set for interlocked operation with Mr. Slim units. - Page 9 ( with cover ) Seal with putty Cable 3. Connect the cable to the terminal board at the bottom rear of the Lossnay M- NET remote controller unit. ● The cable does not have polarity. ● When connecting stranded cable, hold down the tab on the terminal board Button: while inserting the cable.
- Page 10 CAUTION: The address must be set if the Lossnay M-NET remote controller is to be used as a part of a multi-unit system. Set the address according to its position in the system. In addition, refer to page 59 for more information concering the setting of the addresses.
-
Page 11: Setting Procedure
A Lossnay unit must be registered with the Lossnay M-NET remote controller in a group arrangement. Register a Lossnay unit using the initial registration mode as shown below. In addition, the initial registration mode can be used to search for a Lossnay unit registered to the group or to delete a registration. - Page 12 ● If the registration cannot be completed or deleted correctly, either the set address or the wiring of the Lossnay unit whose registration you wish to add or delete may be incorrect. Check the wiring and the address that is set.