Table of Contents
Advertisement
GROUP SETTING
G03
ADDRESS
UNIT
005
006
REMOTE CONTROLLER
SYSTEM CONTROLLER
PLEASE WAIT
Additions:
Deleting all group configuration data.
Display "G00"on the group configuration setting screen and press the
group configuration data and all interlocked operation data.
Note:
Group registration cannot be made when this unit is set to the slave system controller by the DIP switch No. 2. However, con-
firmation of the contents of the group registration is possible.
To change the group configuration setting, set DIP switch No. 1 in the cover to ON. This will bring up the initial setting menu
screen. From that screen, select "1 GROUP SETTING" on the setting menu screen. Wait for the screen to appear and then
change the setting.
This is the procedure for registering all units and controllers in the displayed
group number.
6 Repeat operation 3 to 5 to set all the groups controlled by this controller.
7 When all settings have been completed, press the
Note:
Be sure to set the local remote controller address when there is a local remote
controller in the system. The local remote controller will not operate if the
address setting is not performed.
8 The initial setting screen is displayed.
Registration processing for the group configuration information and initial set
up processing for each unit and each controller is executed when DIP switch
No. 1 is set to OFF.
(This process takes approximately five minutes.)
Note:
If DIP switch No. 1 is set to ON at this time, the initial setting menu screen is
displayed without the initial setting screen.
9 The user operation menu is displayed.
Once the group configuration settings are completed, user operation can be
performed. Refer to Section "15.1.4 Interlocked Operation Setting" when per-
forming interlock operation settings.
BACK
SCREEN
button two times consecutively to delete all
DEL.
button.
185
Advertisement
Table of Contents
