GE ApexPro Operator's Manual page 98

Managing patients
6-12
a. When you see an empty patient window displaying an Admit button, go to
step 2.
b. If you do not see an empty patient window displaying an Admit button, click
Auto Display in the menu bar. When the Auto Display button is enabled, the
multi-patient viewer rearranges itself and should add at least one empty
patient window with an Admit button:
NOTE
To enable or disable the Auto Display feature, from the multi-
patient viewer, click Setup CIC > CIC Defaults > Display
Configuration > Auto Display.
i. When you see an empty patient window displaying an Admit button, go
to step 2.
ii. If the message, Reconfiguration Failed appears, the multi-patient
viewer is full of admitted patient windows and no empty patient
windows are available. Use the following procedures (in the order
presented) to remove displayed patient beds from the multi-patient
viewer before you can admit a new patient:
See Removing viewed out-of-unit patient beds on page 7-6.
See Viewing patient beds from another in-unit CIC Pro center on
page 7-5.
See Discharging an admitted patient on page 6-19.
c. When a Discharged message is displayed in an unlocked patient window,
you must clear the discharged bed from this unlocked window before you
can admit a patient to this window. To clear the discharged bed, complete the
following procedure:
i. Right click in the patient window you need to clear. The right click
menu displays.
ii. From the right click menu, click Select Care Unit then Bed Number >
None. The patient window should now be empty except for an Admit
button. Go to step 2.
2. Click Admit to display the Admit window.
To automatically enter the patient demographics
ApexPro™
057A
2001989-200E