Panasonic EBL512 Operating Instructions Manual page 6

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00748 Rev: 1 Operating Instructions Fire alarm system EBL512 V2.3.x
26.5.1 Reset of a week average sensor value _____________ 94
26.5.2 Algorithm setting via menu H4/U5 _______________ 95
26.6 Sensors activating SERVICE signal (H4/U6) ___________ 100
26.7 Event log (H4/U7)________________________________ 101
26.8 Configuration (H4/U8) ____________________________ 102
27 Service (H5) ______________________________ 103
27.1 Access code for service (H5) _______________________ 104
27.2 Calibration of supervised outputs (H5/A1) _____________ 105
27.3 Sensitive fault detection mode (H5/A2) _______________ 106
27.4 Direction for communication on COM-/BS4-loop (H5/A3) 107
27.5 Show information about Site Specific Data (H5/A4) _____ 108
27.6 Display current consumption in unit (H5/A5)___________ 109
27.7 Display current consumption COM-/BS4-loop (H5/A6) __ 110
27.8 Display statistics for COM-loop (H5/A7)______________ 111
27.9 Select unit on COM-loop to use for trigging (H5/A8) ____ 112
27.10 Activate address setting mode for DU (H5/A9) ______ 113
27.11 Change access code for PC-communication (H5/A10) _ 114
27.12 Change access code for service (H5/A11) ___________ 115
28 Acknowledge FAULTS (H6) ________________ 116
29 Perform ZONE TEST (test mode) (H7) _______ 117
30 Maintenance (H8) _________________________ 119
30.1 Access code for maintenance _______________________ 119
30.2 Disable or re-enable outputs for routing equipment (H8/S1)120
30.3 Disconnect loop (H8/S2)___________________________ 121
30.4 Re-connect loop (H8/S3)___________________________ 122
30.5 Acknowledge SERVICE signal (H8/S4)_______________ 123
30.6 Clear weekly average (H8/S5) ______________________ 124
30.7 De-activate alert annunciation function (H8/S6)_________ 125
30.8 Test alarm devices (H8/S7) _________________________ 126
30.9 Safe shut down of control unit (H8/S8) _______________ 127
30.10 Activate address in alarm mode (H8/S9) ____________ 128
30.11 Synchronize the control units (H8/S10)_____________ 130
30.12 Change access code for maintenance (H8/S11)_______ 132
31 Interlocking outputs and inputs (H9) _________ 133
31.1 Activated interlocking outputs/inputs (H9/C1) __________ 133
31.2 Activate interlocking output (H9/C2) _________________ 134
31.3 Reset interlocking output (H9/C3) ___________________ 135
31.4 Disable interlocking output (H9/C4)__________________ 136
31.5 Re-enable interlocking output (H9/C5)________________ 137
32 Change access code for daily duties (H10) _____ 138
33 Annual control ___________________________ 139
34 How to change paper in the printer __________ 140
4