Table of Contents
Advertisement
Moto G (4th Generation)
Level 2 – Service and Repair Manual
PCB Removal
NOTE
The PCB can be recovered and
reused after removal.
1.
Use the Tweezers to peel the Copper Tape
from the Display Flex BtB Connector.
NOTE
After you remove the Copper Tape,
you cannot reuse it.
2.
Use the flat end of the Blackstick to
disengage the Display Flex BtB Connector.
3.
Use the flat end of the Blackstick to
disengage the Fingerprint Sensor Flex BtB
Connector.
NOTE
The Fingerprint Sensor is only available on the
16 MP model.
4.
Use the Tweezers to remove the Kapton Tape
from the 3IP Machine Screw near the SIM
Trays.
NOTE
After you remove the Kapton Tape, you
cannot reuse it.
PAGE 35
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola
Advertisement
Table of Contents
