Front Housing Preparation - Lenovo motorola Moto G Service And Repair Manual

Moto G (4th Generation)
Level 2 – Service and Repair Manual

Front Housing Preparation

Description
ASSY,HSG,FRNT,WHT
ASSY,HSG,FRNT
DIE CUT,ADHES,DISP FLEX,GROUNDING CPSA-T
DIE CUT,ADHES,DISP FLX TO FRNT HSG CHAS
DIE CUT,ADHES,DISP FLX GNDNG CPSA-LED AR
SCRN,MIC,MESH,PRIMARY
SCRN,MESH,SPEAKER
SPCR
TAPE,KAPTON,FRONT,R_DFP
LBL,IMEI
TAPE,DISP FLX PROT FROM BAT WALL
1. Remove the two Ground Flex Adhesives from
their carriers.
2. Place the Adhesives on the Front Housing in
the locations shown. Align the edge of each
Adhesive with the edge of the slot in the Front
Housing.
3. Press down on the Adhesives for 5 seconds
to secure them to the Front Housing.
4. Remove the Microphone Mesh from the
carrier.
5. Place the Microphone Mesh on the bottom of
the Front Housing, aligning it with the etched
recess.
6. Press down on the Microphone Mesh for 5
seconds to secure it to the Front Housing.
PAGE 112
Reference #
1.3
1.7
1.8
--
1.9
1.4
--
--
--
--
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola