Moto G (4th Generation)
Level 2 – Service and Repair Manual
Rear Housing Removal
NOTE
The Rear Housing can be recovered
and reused after removal.
1.
Use the Torque Driver and 3IP Torx Bit to
remove the 19 3IP Machine Screws from the
Rear Housing.
NOTE
After you remove the 3IP Machine
Screws, you cannot reuse them.
2.
Use the flat end of the Blackstick to
disengage the snap at the top right of the
Front and Rear Housings.
3.
Use the flat end of the Blackstick to
disengage the snap at the bottom left of the
Front and Rear Housings.
PAGE 21
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola