Setting The Ups2000G-B Device Address - Huawei ECC500 User Manual

ECC500
User Manual
Figure 4-23 LCD screen display
Procedure
Step 1 Operate the DIP switch S2 on the optional Modbus card to set the UPS2000G-A device
address.
Toggles 1 to 8 of DIP switch S2 specify the device address in binary mode. ON indicates 0,
and OFF indicates 1.
Table 4-4 Mapping between device addresses and Modbus card DIP switch settings
Device Toggle
Address Switch 1
1 OFF
2 ON
3 OFF
4 ON
----End

4.4.3 Setting the UPS2000G-B Device Address

Context
UPS2000G-B V200R001 is used and equipped with an LCD screen, as shown in
Issue 03 (2020-01-06)
Table 4-4
Toggle Toggle
Switch 2 Switch 3
ON ON
OFF ON
OFF ON
ON OFF
Copyright © Huawei Technologies Co., Ltd.
shows an example of the switch settings.
Toggle Toggle
Switch 4 Switch 5
ON ON
ON ON
ON ON
ON ON
4 Installation and Commissioning
Toggle Toggle
Switch 6 Switch 7
ON ON
ON ON
ON ON
ON ON
Toggle
Switch 8
ON
ON
ON
ON
Figure 4-24.
45