Adding A Water Sensor - Huawei ECC500 User Manual

ECC500
User Manual
Figure 5-12 Adding a door status sensor
----End

5.2.4.4 Adding a Water Sensor

Prerequisites


Context


Procedure
Step 1 Log in to the ECC500 WebUI.
Step 2 Choose Monitoring > MUE05A Expansion Card > MUE05A4 > Running Parameter >
AI/DI_4 Port Settings.
Step 3 Set AI/DI_4 Sensor to Enable.
Step 4 Click Submit.
Step 5 Set AI/DI_4 Sensor Name, for example, to Water_Sensor.
Step 6 Check whether Leak Sensor(NC) is automatically displayed in AI/DI_4 Sensor Type.
Step 7 Set AI/DI_4 Power Supply to On.
Issue 03 (2020-01-06)
You have obtained the ECC500 IP address as well as the user name and password for
WebUI login.
You have prepared a PC which is in the same IP address segment as the ECC500 and
connected the PC to the ECC500 over a switch.
A water sensor should be connected to the AI/DI_4 port on the MUE05A4 of the
ECC500 by default. To connect the water sensor to another port, set the port parameters
using the following method.
A water sensor can be automatically identified. After it is connected to an AI/DI port on
the ECC500. The sensor type is automatically identified and displayed in AI/DI_4
Sensor Type on the ECC500 WebUI.
Copyright © Huawei Technologies Co., Ltd.
5 UI Description
58