How Can I Enable Or Disable An Alarm And Set The Alarm Severity - Huawei ECC500 User Manual

ECC500
User Manual
7.9 How Can I Enable or Disable an Alarm and Set the
Alarm Severity?
Prerequisites


Context


Procedure
Step 1 Log in to the ECC500 WebUI.
Step 2 Choose System Settings > Alarm Parameters.
Step 3 Select System Equipment from the drop-down list box and click Confirm.
Step 4 Set ECC500 network fault to Enable or Disable and set Severity, as shown in
Figure 7-10 Enabling or disabling an alarm and setting the alarm severity
Step 5 Click Submit.
----End
Issue 03 (2020-01-06)
You have obtained the ECC500 IP address as well as the user name and password for
WebUI login.
You have prepared a PC which is in the same IP address segment as the ECC500 and
connected the PC to the ECC500 over a switch.
Enable or disable an alarm and set the alarm severity depending on actual requirements.
If an alarm is set to Disable, the ECC500 will not report this alarm.
The setting methods for diverse alarms are the same. This section describes how to set
ECC500 network fault for System Equipment.
Copyright © Huawei Technologies Co., Ltd.
7 FAQ
Figure 7-10.
95