ECC500
User Manual
4.3.2 Connecting the UPS2000G-A Monitoring Cable
Context
Procedure
Step 1 Prepare RJ45 connectors on both ends of a network cable, as shown in
Step 2 Plug one RJ45 connector to an RS485 port in the ECC500 and the other one to the RS485 port
in the UPS2000G-A.
----End
4.3.3 Connecting the UPS2000G-B Monitoring Cable
Context
Issue 03 (2020-01-06)
The cable connection method described in the section applies to cable connections from
the ports of the RS485 expansion card in the ECC500 to devices.
UPS2000G-A V100R001 is used and equipped with an LCD screen, as shown in
4-15.
Figure 4-15 LCD screen display
When connecting a UPS2000G-B to the ECC500, perform the following steps to prepare
a special monitoring cable.
The cable connection method described in the section applies to cable connections from
the ports of the RS485 expansion card in the ECC500 to devices.
UPS2000G-B V200R001 is used and equipped with an LCD screen, as shown in
4-16.
Copyright © Huawei Technologies Co., Ltd.
4 Installation and Commissioning
Figure
4-13.
Figure
Figure
39