GE DigitalFlow XGS868i Programming Manual page 127

Analog Outputs (cont.)
Note:
All the options shown below will only appear if Mass Flow is activated.
Option Bar
Velocity Displays the flow velocity.
Volumetric Displays the volumetric flow.
FWD Total Displays the forward totalized volume flow.
REV Total Displays the reverse totalized volume flow.
Time Displays the total flow measurement time.
Mass Flow Displays the mass flow.
FWD Mass Displays the forward totalized mass flow.
REV Mass Displays the reverse totalized mass flow.
UP Sig Strength Displays signal strength for upstream transducer.
DN Sig Strength Displays signal strength for downstream transducer.
Soundspeed Displays measured speed of sound in the gas.
UP Transit Displays upstream ultrasonic signal transit time.
DN Transit Displays downstream ultrasonic signal transit time.
Displays transit time difference between the upstream and
DeltaT
downstream signals.
Reynolds # Displays the Reynolds number.
K factor, based on the Reynolds number.
K(Re)*MultiK *KFactor
PEAK% Displays the percentage of peak (set to +50 by default).
UP Signal Q Displays signal quality for upstream transducer.
DN Signal Q Displays signal quality for downstream transducer.
Displays the value for the signal amplitude of the upstream
UP Amp Discrim
transducer.
Displays the value for the signal amplitude of the downstream
DN Amp Discrim
transducer.
UP+-Peak Displays signal peaks for upstream transducer.
DN+-Peak Displays signal peaks for downstream transducer.
UP DAC COUNTS Displays AGC DAC count for upstream gain setting.
DN DAC COUNTS Displays the AGC DAC count for the downstream gain setting.
Temperature Displays gas temperature (from 0/4-20 mA input)
Pressure Displays the gas pressure (from 0/4-20 mA input).
Compress Displays the compressibility factor.
Act Vol. Displays actual volumetric flow.
Std Vol. Displays standard volumetric flow.
Displays Skan transit time upstream.
2
UP Transit S
Displays Skan transit time downstream.
2
DN Transit S
DigitalFlow™ XGS868i Programming Manual
Table 27: Available Measurement Parameters
Description
Appendix C. Programming the XGS868i Using PanaView™
50–75
50–75
0.3 - 3.0
>|800|
>|800|
24 ± 5
24 ± 5
100-2300 <100 or >2300
100-2300 <100 or >2300
Good Bad
N.A. N.A.
N.A. N.A.
N.A. N.A.
N.A. N.A.
N.A. N.A.
N.A. N.A.
N.A. N.A.
N.A. N.A.
<50 or >75
<50 or >75
N.A. N.A.
N.A. N.A.
N.A. N.A.
N.A. N.A.
N.A. N.A.
N.A.
N.A. N.A.
<|800|
<|800|
<19 or >29
<19 or >29
N.A. N.A.
N.A. N.A.
N.A. N.A.
N.A. N.A.
0 – 1 <0 or >1
N.A. N.A.
N.A. N.A.
N.A. N.A.
N.A. N.A.
117