Document User/Request To The Reader; Target Audience, Prerequisites; Glossary - Siemens RDG200KN Basic Documentation

1.3.4 Document user/request to the reader

1.4 Target audience, prerequisites

1.5 Glossary

A6V11545892_en--_a
Before using products from Siemens Industry, Inc., it is important that you read the
documents supplied with or ordered at the same time as the products (equipment,
applications, tools, and so on) carefully and in full.
We assume that persons using our products and documents are authorized and
trained appropriately and have the technical knowledge required to use our
products as intended.
More information on the products and applications is available:
● On the intranet (Siemens employees only) at
https://wse04.siemens.com/content/P0002723/SitePages/Home.aspx
● From the Siemens branch office near you
www.buildingtechnologies.siemens.com
● From the support team at headquarters
if there is no local point of contact
Siemens assumes no liability to the extent allowed under the law for any losses
resulting from a failure to comply with the aforementioned points or for the
improper compliance of the same.
This document assumes that users of the RDG2..KN room thermostats are familiar
with the ETS tool, Synco ACS tool or both and can use them.
It is also assumed that these users are aware of the specific conditions associated
with KNX.
In most countries, specific KNX know-how is conveyed through training centers
certified by the KNX Association (see www.knx.org/).
For reference documentation, see Reference documents [➙ 5].
The inputs, outputs and parameters of an application can be influenced in various
ways. These are identified by the following symbols in this document:
Parameters identified by this symbol are set using ETS.
Parameters identified by this symbol are set using ACS.
Setting RDG2..KN KNX parameters is only supported by the
following tool versions:
● ETS5 or higher versions
● ACS version 13.03 or higher
Note!
Inputs and outputs identified by this symbol communicate with
other KNX devices.
They are called communication objects (CO).
The communication objects of the RDG2..KN works partly in S-
Mode, partly in LTE-Mode, and partly in both. These objects are
described accordingly.
A list of the parameters is shown in Control parameters [➙ 108].
About this document
Target audience, prerequisites
or from your system supplier
fieldsupport-zug.ch.sbt@siemens.com
1
7 | 150