Toro 2024 Directional Drill Software Manual page 9

11. Hold the lower section of the rocker switch
(Figure 38) until the arms retract and the cam
assembly returns to the home position (row 3)
(Figure 39).
Figure 37
Figure 38
Figure 39
12. Release the rocker switch to start the push-pipe
process again. The cam assembly will go to
the row picked in step
SmartTouch Mode (page
Hours Screen Options
Machine Hours Screen
To access this screen push button 1 on the Hours
screen.
This screen shows the operating hours of the
g210532
machine. Machine 1 cannot be changed. Machine
2 can be reset.
Button 5 shows the total engine hours.
Button 6 shows engine hours that can be reset by
pushing button 8.
g210462
g210531
9
2 of Pulling Pipe in
2).
Figure 40
g207716