Toro 2024 Directional Drill Software Manual page 14

I/O Screens
Joystick I/O Screen
Push button 1 on the I/O screen to access the Joystick
I/O screen.
When the rocker switch on the left control panel is in
the Drill position, the upper left icon turns green and
you can check the joystick voltages as well as verify
the 2–Speed and Exit Side Lockout.
When the rocker switch is in the Setup position, the
upper right icon is green. The setup position allows
you to move the machine and prepare for drilling.
Figure 54
•
The rotary voltage ranges from 0.0 to 8.5 V and
be present for either make (upper icon) or break
(lower icon) as the selected rotary joystick is
moved.
•
The carriage indicates a range from 0.0 to 10.0
volts in the joystick selected direction for thrust or
pullback.
•
The lower left icon indicates the carriage position
of wrench, load, or carriage back as the carriage
moves to the most rearward positions.
•
The lower center icon indicates if the 2-speed
selection of the carriage speed has been selected.
•
The lower right icon indicates the status of the Exit
Side Lockout (ESL). If the indicator is black, the
carriage and rotary actions are inhibited.
Engine I/O Screen
To access this screen push button 2 on the I/O screen.
This screen displays engine information.
1. Engine speed (rpm)
2. Engine oil pressure
3. Battery voltage
g034769
4. Engine temperature
Engine speed (rpm): displays, in steps of 100, the
engine speed (rpm).
Engine oil pressure: displays the engine oil pressure
(bar or psi).
Battery voltage: displays the battery voltage.
If the engine is off, the voltage is measured by the
Toro controller.
Engine temperature: displays the engine coolant
temperature. The temperature drops to 40°F when
the engine is off.
Air filter: the air filter icon is green unless the filter is
plugged then the indicator is red.
Hydraulic fluid filter: the hydraulic fluid filter icon is
green unless the filter is plugged then the indicator
is red.
Engine droop: use the up and down arrows to select
the maximum allowable engine droop in the range of
50, 75, and 80 percent. The droop value is the lowest
point below low-load speed (rpm) (under 75 percent
load) that the engine may decrease before the drive
to the rotary head is decreased to maintain the lowest
value.
14
Figure 55
5. Air filter indicator
6. Hydraulic oil filter
7. Engine droop
8. Water in fuel indicator
g204577