Toro 2024 Directional Drill Software Manual page 2

1. Pull pipe
2. Push pipe
3. Rotary torque
SmartTouch™ Home Screen
SmartTouch mode allows the operator to load and
unload pipes from the rod box with less joystick
operation to reduce operator fatigue.
Use the Carriage Settings Screen (page 12)
SmartTouch mode on and off.
Note:
The Push/Pull Icon will have a green
background when SmartTouch mode is on and a
ribbon will appear at the bottom of the screen showing
a sequence of the steps.
Important:
Never switch between Push/Pull
modes during the chosen operation. Use neutral
(manual) mode to switch between Push/Pull; refer
to Carriage Settings Screen (page 12)
SmartTouch mode off.
Figure 3
4. Thrust force
5. Drill speed (rpm)
to turn
Pulling Pipe in SmartTouch Mode
Start the SmartTouch mode with the cam assembly in
the home position (row 3 of the pipe box).
Important:
of the cam rocker switch, on the left joystick,
completely down until the action is complete in
each step
g210057
Hold the upper section of the cam rocker switch,
on the left joystick, completely down until all
actions are complete to go to the previous step in
the sequence
to turn
1. Push button 1 to select the pull pipe option
(Figure
2
Ensure that you hold the lower section
(Figure 4).
Figure 4
(Figure 5).
Figure 5
6).
g210060
g210061