Toro 2024 Directional Drill Software Manual page 6

Pushing Pipe in SmartTouch Mode
Start the SmartTouch mode with the cam assembly in
the home position (row 3 of the pipe box).
Important:
Ensure that you hold the lower section
of the cam rocker switch, on the left joystick,
completely down until the action is complete in
each step (Figure 22).
Hold the upper section of the cam rocker switch,
on the left joystick, completely down until all
actions are complete to go to the previous step in
the sequence (Figure
Figure 22
23).
Figure 23
1. Push button 1 to select push pipe
2. Push buttons 2 and 3 to select the row where
you want to get the pipe
g210060
1. Push pipe
3. Hold the lower section of the rocker switch
(Figure 26) until the cam assembly rotates to
the selected row and the pipe lowers into the
opening
g210061
6
(Figure
Figure 24
2. Select pipe row
(Figure 27).
Figure 25
(Figure 24).
24).
g210063
g210464