Toro 2024 Directional Drill Software Manual page 3

2. Push buttons 2 and 3 to select the row where
you want to place the pipe
Figure 6
1. Pull pipe
3. Hold the lower section of the rocker switch
(Figure 8) until the elevator lowers, the cam
assembly rotates toward the operator station,
and the arms fully extend
Figure 7
Figure 8
(Figure 6).
g210062
2. Select pipe row
(Figure 9).
g210518
g210462
4. Release the rocker switch to proceed to the next
step in the sequence
5. Break the pipe connection; refer to Removing
Drill Pipes in the Operator's Manual.
3
Figure 9
(Figure 10).
Figure 10
g210517
g210520