Toro 2024 Directional Drill Software Manual page 12

Settings Screen Options
Carriage Settings Screen
Push button 1 on the Settings screen.
Use this screen to change the carriage settings. Push
the up and down arrows to rotate between: push pipe,
pull pipe, and neutral.
Figure 47
1. Pull pipe
2. Push pipe
Push the OK button to turn SmartTouch mode on and
off.
Figure 48
g208586
3. Neutral
g210058
Push Pipe: refer to Starting the First Pipe and Adding
Drill Pipes in the Drilling the Bore section in your
Operator's Manual for full instructions.
Pull Pipe: refer to Removing Drill Pipes in the Drilling
the Bore section in your Operator's Manual for full
instructions.
Control Mode Screen
Push button 2 on the Settings screen.
Use this screen to select between the 2 joystick
control options. Push the up and down buttons to
switch between Mode I and Mode II.
•
Mode I—The right joystick controls the thrust and
the rotation functions. The left joystick controls the
wrench and pipe loader functions.
•
Mode II—The right joystick controls the thrust and
the pipe loader elevator function. The left joystick
controls the rotation, wrench, and pipe loader
functions.
12
Figure 49
g034776