7.19 DISPLAY BOARD SUBSTITUTION
1. Disconnect the power supply cord and remove the Oven from the cabinet.
2. Remove the upper cover.
3. Remove the knobs and the glass.
4. Disconnect the bad display board and remove it by the nylon spacers.
5. BEFORE REPLACING THE UNIT, CUT THE RESISTOR FOR OVEN
CONFIGURATION FOLLOWING THE TABLE ON SECTION 2.5.
6. Reinstall the Oven into the cabinet.
7. Reconnect the power supply cord after the Oven is installed.
8. Check the Oven by MANUAL TEST following the procedure shown on
section 2.6.
BWOS 30100 SERVICE MANUAL
67