Lock Door Motor Substitution - Blomberg BWOS 30100 Service Manual

7.8 LOCK DOOR MOTOR SUBSTITUTION

1. Disconnect the power supply cord and remove the Oven from the cabinet.
2. Remove the upper cover.
3. Remove the rear upper cover .
4. Disconnect the cables. Pay attention to the sequence of wiring of the motor (micro).
5. Remove the lateral screws and internal attachment screws for Single Oven and Upper
Cavity of Double oven.
6. If the motor is mounted on Lower cavity of Double Oven remove the lateral screws and
pull up the motor.
7. Disassemble the motor by removing the two screws and remove also the brackets.
8. Replace the new by reversing the previous steps.
9. Pay attention to the positioning when inserting the door lever mechanism into the
eccentric of the motor. Be sure the inside of the mechanism if is lubricated (silicon
grease)
10. Connect the terminals.
11. The connections must not be loose.
12. Reinstall the Oven into the cabinet.
13. Reconnect the power supply cord after the Oven is installed.
14. Run the Oven and check all functions.
BWOS 30100 SERVICE MANUAL
56