Toro Workman GTX Electric & Lithium Service Manual page 68

On- -board Battery Charger
RIGHT
FRONT
1. On- -board battery charger
2. Heat shrink tube
3. Cord set
4. Lock nut (2 used)
5. Screw (2 used)
6. AC power cord
IMPORTANT: No serviceable parts (including elec-
trical conductors) are contained inside the battery
charger. DO NOT attempt to open or disassemble
the charger.
Removal (Fig. 55)
1. Park vehicle on a level surface, turn key switch to
OFF, engage the parking brake and remove key from
the key switch. Make sure that vehicle charger IS NOT
connected to electrical outlet.
2. Raise cargo bed and support with prop rod. Remove
seat base assembly.
Electrical System
14
10
13
11
Figure 55
7. LED holder
8. Charger function decal
9. LH seat base side
10. Screw (4 used)
11. Charger bracket
3. Remove rear frame panel cover to allow access to
battery charger electrical connections (see Rear Frame
Panel Cover in the General Information section of this
chapter).
4. Open the battery circuit by disconnecting the con-
ductors between the battery pack and vehicle compo-
nents (see Opening Battery Circuit in the General
Information section of this chapter).
NOTE: Label all battery charger electrical leads for as-
sembly purposes.
Page 3A - - 48
16
15
2
12
1
5
8
7
12. Flange head screw (4 used)
13. Flange nut (4 used)
14. Washer head screw (2 used)
15. Controller
16. Main contactor
3
4
9
6
Workman GTX Electric