Front Brake Calipers - Toro Workman GTX Electric & Lithium Service Manual

Front Brake Calipers

4
10
2
54 to 66 in- -lb
(6.1 to 7.4 N- -m)
35 to 40 ft- -lb
(48 to 54 N- -m)
Medium Strength
Threadlocker
1. LH brake caliper
2. RH brake caliper
3. Socket head screw (2 per caliper)
4. Wheel hub assembly (2 used)
Disassembly (Fig. 13)
1. Park vehicle on a level surface, turn key switch OFF,
apply parking brake and remove key from the key
switch.
WARNING
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 - - Safety.
2. Chock wheels not being removed. Use a jack to raise
front wheel that is to be removed off the ground. Support
vehicle with appropriate jack stands beneath the frame.
3. Remove front wheel from machine (see Front
Wheels and Hubs in this section).
Chassis
9 to 11 ft- -lb
(13 to 14 N- -m)
5
6
7
8
3
9
108 to 132 in- -lb
(12.3 to 14.9 N- -m)
5. Brake rotor (2 used)
6. Socket head screw (4 per rotor)
7. Spindle (RH shown)
8. Front brake line
1
Figure 13
4. Disconnect brake line from front caliper (Fig. 14):
A. Clean hydraulic brake line area of brake caliper to
prevent contamination of brake system.
B. Remove banjo bolt that secures brake line fitting
to caliper.
C. Carefully separate brake line from caliper. Locate
and retrieve two (2) banjo washers from sides of
brake line fitting.
D. Plug brake line and position it away from caliper.
5. Remove two (2) socket head screws that secure the
brake caliper to the spindle.
6. Slide brake caliper from brake rotor and remove cali-
per from vehicle.
Page 5 - - 16
11
9. Banjo bolt
10. Bleed screw
11. Washer head screw
Workman GTX Electric
RIGHT
FRONT