While Operating; Maintenance And Service - Toro Workman GTX Electric & Lithium Service Manual

While Operating

1. Sit on the operator seat when starting and operating
the vehicle.
2. Before starting the vehicle:
A. Make sure that the AC power supply cord (exten-
sion cord) is disconnected from the vehicle onboard
charger receptacle.
B. Engage the parking brake.
C. Make sure accelerator pedal is not depressed.
D. Check position of direction selector switch and
supervision speed limit switch.

Maintenance and Service

1. Before servicing or making adjustments to the ve-
hicle, stop vehicle, turn key switch to OFF, engage park-
ing brake and remove key from the key switch.
2. Make sure machine is in safe operating condition by
keeping all nuts, bolts and screws tight.
3. Do not use open pans of flammable cleaning fluids
for cleaning vehicle parts.
4. Keep battery area free of excessive grease, grass,
leaves and dirt.
5. As the first step in any electrical system repair, open
the battery circuit by disconnecting the conductors be-
tween the battery pack and vehicle components (see
Opening Battery Circuit in the General Information sec-
tion of Chapter 3 − Electrical System). Take care during
repairs, however, to not allow tools or vehicle compo-
nents to complete the battery circuit that was opened.
Connect the conductors between the battery pack and
vehicle components as the last step in the repair.
6. When using metal, uninsulated tools around batter-
ies, do not allow tools to contact both positive and nega-
tive battery terminals simultaneously.
7. Remove jewelry and watches before servicing elec-
trical components of the vehicle.
8. Battery acid is poisonous and can cause burns.
Avoid battery acid contact with skin, eyes and clothing.
Protect your face, eyes and clothing when working with
batteries.
9. Battery gases can explode. Keep cigarettes, sparks
and flames away from the batteries. Always service,
store and charge the vehicle batteries in a well ventilated
area.
Workman GTX Electric
3. Before getting off the operator seat:
A. Stop vehicle, turn key switch to OFF and remove
key from switch.
B. Apply the parking brake.
4. If vehicle is parked on incline, chock or block the
wheels after getting off the vehicle.
10.When connecting the AC power supply cord (exten-
sion cord) to the vehicle onboard battery charger, con-
nect the power supply cord to the vehicle charger
receptacle before plugging the supply cord into an AC
outlet (electrical supply for charger). After charging the
vehicle batteries, unplug the supply cord from the outlet
before disconnecting the supply cord from the vehicle
charger receptacle.
11. If major repairs are ever needed or assistance is de-
sired, contact an Authorized Toro Distributor.
12.To assure optimum performance and continued
safety of the machine, use genuine Toro replacement
parts and accessories. Replacement parts and acces-
sories made by other manufacturers may result in non-
conformance with safety standards and the warranty
may be voided.
13.When raising the machine to change tires or to per-
form other service, use correct blocks, hoists and jacks.
Make sure machine is parked on a solid level surface
such as a concrete floor. Prior to raising the machine, re-
move any attachments that may interfere with the safe
and proper raising of the machine. Always chock or
block wheels that remain on the ground for vehicle sta-
bility. Use jack stands to support the raised machine. If
the machine is not properly supported by jack stands,
the machine may move or fall, which may result in per-
sonal injury (see Jacking Instructions in the Operator's
Manual and in this Chapter).
14.Make sure to dispose potentially harmful waste (e.g.
batteries, oil) in an environmentally safe manner. Follow
all local codes and regulations when recycling or dispos-
ing of waste.
Page 1 − 3 Safety