Toro Workman GTX Electric & Lithium Service Manual page 135

5. Disconnect charger electrical conductors from vehi-
cle connections:
A. Unplug the power supply cord (item 3) from the
battery charger (item 1).
B. Disconnect the charger interface wire harness
(item 5) from the machine wire harness (item 8).
C. If necessary, remove two (2) nuts (item 9) and
bolts (item 12) that secures the AC input cord (item
10) to the charger outlet bracket (item 13). Separate
AC input cord from the charger outlet bracket.
6. Support battery charger to prevent it from falling.
7. Remove four (4) flange head bolts (item2 ) that se-
cure the battery charger to the charger bracket. Careful-
ly remove charger with attached charger interface wire
harness from vehicle.
8. Check that cooling fins on charger are free of accu-
mulation of dirt and debris. Carefully clean charger fins
if necessary.
9. If necessary, remove the charger interface wire har-
ness from the battery charger using Figure 70 as a refer-
ence.
Installation (Fig. 69)
1. If removed, install the charger interface wire harness
onto the battery charger using Figure 70 as a reference.
2. Position battery charger to charger bracket. Secure
charger to bracket with four (4) flange head screws.
Torque tighten the screws to 90 to 110 in- -lb (10 to 12.4
N- -m)
3. Connect the charger electrical conductors to vehicle:
A. If removed, install the charger AC input cord
(item10) to the charger outlet bracket (item 13) with
two (2) bolts (item 12) and nuts (item 9).
Workman GTX Electric Lithium
B. Connect the charger interface wire harness (item
5) to the machine wire harness (item 8).
C. Plug--in the power supply cord (item 3) to the bat-
tery charger (item 1).
4. Connect the conductors between the battery pack
and vehicle components (see Opening Battery Circuit in
the General Information section of this chapter). Make
sure to torque hex nuts on battery terminals from 72 to
88 in- -lb (8 to 9 N- -m).
5. Secure rear frame panel cover to vehicle. Lower and
secure cargo bed. Install seat base assembly.
6. Before returning vehicle to operation, fully charge
the batteries by connecting the on--board battery char-
ger to an appropriate electrical outlet.
45 to 55 in- -lb
(5 to 6.2 N- -m)
36 to 44 in- -lb
(4 to 5 N- -m)
7
1. Nut, battery negative (- -) (black and white wires)
2. Nut, battery positive (+) (red wire)
3. Charger cap
4. Screw (2 used)
5. Screw (2 used)
6. Charger interface wire harness
7. Battery charger
Page 3B - - 65
16 in- -lb
3 4
(1.8 N- -m)
2 5
5.3 in- -lb
(0.6 N- -m)
1
Figure 70
Electrical System
6