Toro Workman GTX Electric & Lithium Service Manual page 191

Removal (Fig. 40)
1. Park vehicle on a level surface, turn key switch OFF,
apply parking brake and remove key from the key
switch.
2. Raise hood to allow access to wire harness connec-
tions to switches mounted in dash.
3. Disconnect wire harness connectors from all switch-
es and power ports on dash.
4. Remove ten (10) washer head screws that secure
dash to vehicle.
5. Carefully lift dash from vehicle supports and remove
it from the vehicle.
Workman GTX Electric
Installation (Fig. 40)
NOTE: Do not fully tighten fasteners securing dash un-
til all fasteners are in place.
1. Carefully position dash to vehicle by lowering it over
parking brake lever.
2. Secure dash with removed washer head screws us-
ing fastener torque specifications that are identified in
Figure 40.
IMPORTANT: Make sure that the USB power point is
connected with the correct polarity. The white (posi-
tive) harness wire should be connected to the upper
USB power point terminal.
3. Connect wire harness connectors to all switches and
power ports on dash.
4. Lower and secure front hood.
Page 5 - - 43 Chassis