Commissioning The Bts (Transmission Available) - Huawei BTS3900 GSM Commissioning Manual

BTS3900(A) GSM
Commissioning Guide
4
Commissioning the BTS (Transmission
About This Chapter
This describes how to commission the BTS when the transmission cable between the BSC and
the BTS is properly connected.
4.1 Starting the LMT
You can directly log in to the LMT, or log in to the LMT through the M2000 client.
4.2 Checking the Transmission and Networking
This describes how to check the transmission and networking. The purpose of checking the
transmission and networking is to ensure that the BTS3900A transmission cables and hardware
are correctly installed. The items to be checked consist of the transmission between the BBU
and the BSC, the transmission between the BBU and the RFU, the transmission between the
cascaded BTSs, and the transmission between the BTSs in ring topology.
4.3 Checking Software Version and Data Configuration
This describes how to check software version and data configuration to ensure the correctness
of the software version and configuration data. The items to be checked are the configuration
and status of the board, the software version information, and the consistency between the
hardware installation and the data configuration.
4.4 Checking the Alarm Information of the BTS (on the LMT)
This describes how to check the alarm information of the BTS on the BSC6000 Local
Maintenance Terminal. If an alarm is generated, you need clear the alarm based on the
suggestions in the BSS Help System.
4.5 Commissioning the BTS Services
This describes how to use an MS to test whether the BTS supports CS services and PS services.
4.6 Checking the BTS Environment Alarms
This describes how to check the BTS environment alarms. It also describes how to monitor the
operating environment of the BTS.
Issue 02 (2009-04-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

4 Commissioning the BTS (Transmission Available)

Available)
4-1