Advertisement
Chapter
8
The IP-DECT base station access points are fitted with 2 LEDs that provide information about the
status.
•
Top LED – Yellow
This LED represents the status of the IP-DECT base station.
LED Status (Top LED, Yellow)
Off
0,5 sec. On - 0,5 sec. Off
Short flash every 0,25 seconds
Fast blink
Continuous fast blink
Steady On
Note:
The colour of the top LED can be different depending on the operational mode.
•
Normal (single band) mode
In the normal single band mode, the top LED will be Yellow.
•
Dual Band
Mode In Dual Band mode, the LED colour shows the operational frequency:
•
Green: Europe/International
•
Red: North America / USA
•
Lower LED – Red/Green
This LED is used to indicate the start-up and network status.
LED Status (lower LED, Red/Green)
RED Steady on
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual
Device commissioning
8 7 6 5 4 3 2 1
DAP RJ45 Socket
Figure 8.21: Pin Layout Ethernet Connector RJ45 on the DAP
1=
100 Base-T TX+
2=
100 Base- T TX-
3=
100 Base-T RX +
4=
+48 Volt power
5=
+48 Volt Power
6=
100 Base-T RX-
7=
RTN (0 Volt) power
RTN (0 Volt) power
8=
Meaning
No power
Loading software/firmware
IP Network error (not connected, no DHCP/TFTP serv-
er, no DAP Controller
DAP operational, but trying to synchronize to another
DAP
Hardware error
DAP operational (and synchronized to other DAP or is
the synchronization master)
Meaning
Power but FPGA starting up
168/216
Advertisement
