Advertisement
Chapter
8
3. Configure the user name and password and consult the SIP password in OMC, refer to
the user name and password in OMC
4. Export the server certificate from the OXO Connect: refer to
OXO Connect
5. Enter the SIP password through MMI, refer to
page 129
6. Upload the certificate on the 4135 IP Conference Phone
8.1.3.1.2.1 Prerequisites
•
The OXO Connect must be operational
•
For network configuration, any of the following must be implemented:
•
In dynamic mode, a DHCP server must be configured
•
In static mode, a free IP address must be available for the set
•
A port with PoE must be available on a switch
8.1.3.1.2.2 Configuring the user by OMC
This paragraph applies to OMC configuration of sets initializing in static mode. In dynamic (DHCP)
mode, the following operation is not mandatory but the server certificate must be exported from the
OXO Connect to the PC and can then be uploaded to the 4135 IP Conference Phone.
To create a 4135 IP Conference Phone:
1. In OMC, go to Users/Base stations List.
2. Select a No., IP access, enter a name and click the Add button.
3. Select IP terminal and click OK.
4. Select the newly created user in the list and select 4135 IP Conference Phone in the combo box
type.
5. Click the Modify button.
6. Click the newly created user to open the User dialog box.
7. Click the IP/SIP button and enter the MAC adress of the set in the IP Parameters tab.
8. If needed, in the SIP Parameters, click the SIP password reset button to get a new password.
8.1.3.1.2.3 Connecting the set to the LAN
Note:
the set is supplied via Ethernet, so make sure using a 802.3af standard-compatible switch.
To connect the set to the LAN:
1. Turn the set over so that you can see its base.
2. Plug the RJ45 cable into the set's LAN connector.
3. Connect the RJ45 cable to the LAN.
8.1.3.1.2.4 Initializing the sets
This section describes how to:
•
Select the initialization mode
•
Initialize the 4135 IP Conference Phone set
Selecting the initialization type
The default initialization is Dynamic Alcatel.
To select the initialization type, refer to the table below.
8AL91217USAA - Ed. 01 - July 2018 - Installation Manual
Device commissioning
on page 128
on page 128
Exporting the server certificate from the
Entering the SIP password through local MMI
Configuring
on
126/216
Advertisement
