4.5.1. Using a crane to lift a transport unit or the drive by the base
frame
CAUTION
–
To prevent the drive or transport unit from tipping when following
these instructions, use an extra sling around the cabinet for
stabilization (Fig. 4-2).
NOTICE
To prevent deformation of the cabinet:
–
Only use a crane to lift single transport units or the drive by the base
frame.
–
Always observe the center of gravity!
Refer to Fig. 4-1 and Fig. 4-2 when following these ABB recommendations:
–
Use a lift frame or a lift spreader with the crane.
–
If a lift frame or lift spreader is not available, make sure that the slope angle is
a maximum of 15° (see Fig. 4-2).
–
Use lifting equipment (eg, web slings, chain slings, round slings, safety hooks,
shackles) that corresponds to the weight that is to be lifted.
–
Attach the slings to the lifting brackets at the base frame.
–
To prevent the drive or transport unit from crashing if one sling tears, fasten
an extra sling around the cabinet for stabilization.
–
Use appropriate safety hooks or shackles to attach a sling.
–
DO NOT pass a sling through the hole of the bracket.
–
If the slings are too close to the cabinet, protect the edges and the door
handles or levers.
–
Lift the drive or a transport unit slowly and steadily to the required clearance
height, maintaining it in upright position.
–
Check the horizontal position and reposition the slings if necessary.
1
Figure 4-1 Lifting bracket on base frame of a drive and safety hook secured to
lifting bracket
1) Lifting bracket (hole ∅42 mm)
PRODUCT
ACS5000W
Tipping hazard!
Risk of component damage.
2
DOCUMENT KIND
User manual
TRANSPORTATION, STORAGE AND DISPOSAL
2) Safety hook
DOCUMENT ID.
3BHS799208 E01
REV.
LANG.
PAGE
F
en
62/178