8.5. Lamp-test function
The lights and illuminated push buttons on the control compartment can be tested
with the lamp-test function.
The lamp test is activated via the CDP control panel by setting control parameter
16.7 to LAMP TEST. The lamp-test function resets itself after a set time.
8.6. Status messages
The following section lists the status messages of the main operating states that
the drive passes through when:
–
Drive is put into operation (see "8.6.1 Start sequence of the drive" on page 121)
–
Drive is stopped (see "8.6.2 Stop sequence of the drive" on page 122)
–
Fault condition has occurred
The status messages are sent to the higher-level control system and are displayed
on the CDP control panel of the drive.
For information on other status messages (eg, fault status messages), see the
status words in "Appendix G - Signal and parameter table".
PRODUCT
ACS5000W
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS799208 E01
OPERATION
REV.
LANG.
PAGE
F
en
119/178