Selecting The Actual Signals Display - ABB ACS5000 User Manual

If no key is actuated within one minute (an exception from this is the fault memory
display), the CDP control panel automatically returns to the actual signals display
from other modes.
Actual values
For the complete list of selectable actual signals, see "Appendix G - Signal and
parameter table".
The actual values are organized in groups.
Group Description
Group 01 Measured or calculated motor values
Group 02 Measured or calculated drive values
Group 03 Reference values
Group 04 Status signals of S800 I/O system
Group 05 Communication link and MCB status signals
Group 06 Software version, drive and motor nominal values
Group 07 Control words
Group 08 Status words
Group 09 Fault and alarm words
Fault memory
The fault memory display provides information on the 64 most recent fault events
that occurred in the drive. It displays the name of the fault and the time it occurred.
For instructions on how to display and reset the fault memory, see "9.2.2.7
Displaying and resetting an active fault" on page 142.
When the drive generates a fault or alarm, the corresponding message displays
immediately.
Changing from the fault memory display to other modes is possible without
resetting the fault first. If no key is actuated, the fault or alarm message displays
as long as the fault is active.

9.2.2.2. Selecting the actual signals display

To select the actual signals display, press the ACT key.
ACT
PRODUCT
ACS5000W
1 L ->
StateINU
MOTOR SP
POWER
DOCUMENT KIND
User manual
600.0 rpm
ReadyOn
0.00 rpm
0.0 kW
DOCUMENT ID.
3BHS799208 E01
CDP CONTROL PANEL
REV. LANG. PAGE
F en 137/178