Bus Outs; About Stereo Out - Yamaha 006IPTO-F0 Owner's Manual

Digital production console version 2
Table of Contents

Advertisement

7 Bus Outs

This chapter describes how to adjust the DM1000's Stereo Out and Bus Out parameters.

About Stereo Out

The Stereo Out section receives Input Channel and Bus Out 1–8 signals, mixes them into
two channels, processes them using on-board EQ, compressor, etc., then routes them to two
channel output connectors. The following diagram illustrates the Stereo Out signal flow.
• INSERT
This section enables you to route the Stereo Out signals to external devices via the on-board
connectors or I/O cards, or insert internal effects processors.
• ATT (Attenuator)
This section enables you to attenuate or amplify the level of signals to be input to the EQ.
The attenuator prevents post-EQ signals from clipping or corrects signal levels that are too
low.
• 4 BAND EQ (4-band equalizer)
This parametric EQ features four bands (HIGH, HIGH-MID, LOW-MID, and LOW).
• COMP (Compressor)
This dynamics processor can be used as compressor, expander, or limiter. The processor can
be located pre-EQ, pre-[STEREO] fader, or post-[STEREO] fader.
• ON (On/Off)
This button turns the Stereo Out on or off.
• LEVEL
The [STEREO] fader adjusts the Stereo Out output levels.
• Balance
This section enables you to adjust the level balance between the L and R channels of the Ste-
reo Out.
• OUTPUT DELAY (Output delay)
This section delays the output signals. It is mainly used to fine-tune the signal timing.
• METER
This section enables you to switch the metering position of signal levels that are displayed
on the Meter page or by the stereo meter to the right of the screen. (See page 39 for more
information on selecting the metering position.)
Note: By default, the Stereo Out signals are output to OMNI OUT 9–10. However, you can
patch these signals to other output connectors or I/O cards using the Output Patch pages.
(Gain Reduction)
(Out Meter)
METER
METER
COMP
INSERT
INSERT
METER
ON
LEVEL
4BAND
ATT
EQ
Same as stereo master L
Bus Outs
METER
INSERT
BAL
OUTPUT
DELAY
DM1000 Version 2—Owner's Manual
81
7
STEREO L
STEREO R

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd83390Dm 1000

Table of Contents