Solo Setup - Yamaha 006IPTO-F0 Owner's Manual

120
Chapter 10—Control Room Monitoring

Solo Setup

For solo setup, press the MONITOR [DISPLAY] button repeatedly until the Monitor | Solo
page appears.
This page contains the following parameters:
A
SOLO
This parameter turns the Solo function on or off. By default, it is set to Enabled.
B
MODE
This parameter determines how the Solo function works. There are two options. The
setting affects only Input Channels.
• RECORDING............... In Recording Solo mode, soloed Input Channel signals are fed
• MIXDOWN.................. In Mixdown Solo mode, soloed Input Channel signals are fed
C
SEL MODE
This parameter determines how the Input Channels will be soloed when you press the
[SOLO] button of each Channel. There are two options.
• MIX SOLO.................... In Mix Solo mode, any number of channels can be soloed
• LAST SOLO .................. In Last Solo mode, only one channel can be soloed at a time by
DM1000 Version 2—Owner's Manual
1
5
6
8
9
to the Solo bus and output via the Control Room Outputs.
Other buses (Stereo bus and Bus 1–8) are unaffected by this
mode.
to the Stereo bus and output via the Control Room Outputs.
Unsoloed Input Channels are not fed to the Stereo bus while
the Solo function is enabled.
Tip:
• Recording Solo mode is convenient when you wish to monitor certain Input Channels
while recording, since the Stereo bus and Bus 1–8 signals are unaffected
• Mixdown Solo mode is useful when you wish to mute unsoloed Input Channels and feed
soloed Input Channel signals to the Stereo bus during mixdown.
simultaneously.
pressing the [SOLO] button. The Solo function that was previ-
ously enabled for channels is automatically cancelled.
2 3
4
7