Yamaha 006IPTO-F0 Owner's Manual page 288

288
Chapter 20—Other Functions
3 Press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup |
Remote page appears.
This page contains the following parameters:
A
REMOTE FUNCTION
This parameter selects a device to be connected to the DM1000 REMOTE connector.
B
HA section
This section enables you to specify the slot channels that will receive eight channel sig-
nals from AD8HR/AD824s that have their ID numbers set to 1 through 4.
C
HA CONTROL section
This section enables you to set the AD8HR/AD824 channel 1–8 gain and the Phantom
power on or off.
• ID #1–#4........................ These buttons select the AD8HR/AD824s you want to control.
• 1–8 (1st row)................. These parameter controls adjust the gain for AD8HR/AD824
• +48V .............................. When you turn on these buttons, the phantom power on the
• 1–8 (2nd row)............... These parameter controls adjust the cut-off frequency of the
• HPF................................ When you turn on these buttons, the high-pass filter on the
4 Make sure that the REMOTE FUNCTION parameter is set to "HA," and in the
HA section select the slot channels that receive signals from the
AD8HR/AD824s.
5 Use the parameter controls and buttons in the HA CONTROL section to set
the channel gain, turn on/off the phantom power, and adjust the high-pass
filter.
DM1000 Version 2—Owner's Manual
1
3
channels 1–8.
corresponding channels will be turned on.
high-pass filter for the corresponding channels. They are
grayed out and cannot be set for the AD824.
corresponding channels will be turned on. They are grayed out
and cannot be set for the AD824.
2