Input Channels; About Input Channels - Yamaha 006IPTO-F0 Owner's Manual

6 Input Channels

This chapter describes how to adjust the DM1000's Input Channel parameters.

About Input Channels

The input Channel section enables you to adjust the level and tone of the signals input to
the DM1000 and route the signals to Bus 1–8, Stereo Bus, and Aux Out 1–8. The following
diagram illustrates the Input Channel signal flow.
INPUT 1(...48)
• (Phase)
This section switches the phase of input signals.
• GATE
This dynamics processor can be used as a gate or for ducking.
• COMP (Compressor)
This dynamics processor can be used as compressor, expander or limiter. The compressor
can be pre-EQ, pre-fader, or post-fader.
• ATT (Attenuator)
This section enables you to attenuate or amplify the level of signals that will be input to the
EQ. The attenuator enables you to prevent post-EQ signals from clipping and to correct sig-
nal levels that are too low.
• 4 BAND EQ (4-band equalizer)
This parametric EQ features four bands (high, high-mid, low-mid, and low).
• INPUT DELAY (Input delay)
This section enables you to delay input signals. You can use this delay to fine-tune the timing
between channels, or as a delay effect with feedback.
• ON (On/Off)
This section enables you to turn the channel on or off. The channel is muted with the Off
setting.
• LEVEL
This section enables you to adjust the input level of the Input Channel signal.
Input Channels
DM1000 Version 2—Owner's Manual
61
6