Table of Contents
Advertisement
54
Chapter 5—Analog I/O & Digital I/O
Omni Outs
• OMNI OUT connectors 1–12
9
Digital Inputs & Outputs
The DM1000 rear panel features digital input and output connectors that enable you to
connect external digital devices. Any signal path can be patched to these digital inputs and
outputs.
You can also add analog and digital I/Os by installing optional I/O cards in Slots 1 and 2.
Digital I/O Connectors
• 2TR IN DIGITAL connector
These connectors accept signals from a DAT or other 2-track digital recorder or consumer
format digital audio device.
2TR IN
DIGITAL
2
COAXIAL
2TR D1
• 2TR OUT DIGITAL connectors
These connectors output signals to a DAT or other 2-track digital recorder or consumer for-
mat digital audio device.
AES/EBU
SLOT 1–2
These slots allow you to install optional mini-YGDAI (Yamaha General Digital Audio Inter-
face) I/O cards. These cards offer AD/DA conversion, and various analog I/O options and
digital I/O interfaces in all the popular digital audio interconnect formats, including
AES/EBU, ADAT, and Tascam. You can patch signals input at these card connectors to any
Input Channels or Insert Ins (see page 110).
You can patch the card outputs to Bus Outs or Input Channel Direct Outs (see page 115).
DM1000 Version 2—Owner's Manual
INPUT
The DM1000 rear panel features OMNI OUT connectors 1–12 for
8
connecting line-level sources, such as a monitoring system, master
recorder, external effects processor. The OMNI OUT connectors use
balanced XLR-3-32-type jacks, with a rated output level of +4 dB.
These outputs can be patched to Bus Outs and Input Channel Direct
Outs. (See page 113 for more information on patching outputs to the
Omni Outs.)
2TR IN DIGITAL 1 uses an XLR-3-31-type connector and accepts
1
AES/EBU format digital audio.
2TR IN DIGITAL 2 is an RCA phono connector and accepts con-
sumer format (IEC-60958) digital audio.
AES/EBU
You can patch signals input at these connectors to any Input Chan-
nels (see page 114). You can monitor these inputs via the Control
Room monitors by using the MONITOR [2TR D1] and [2TR D2]
2TR D2
buttons.
2TR OUT DIGITAL 1 uses an XLR-3-32-type connector and outputs
1
AES/EBU format digital audio.
2
2TR OUT DIGITAL 2 is an RCA phono connector and outputs con-
sumer format (IEC-60958) digital audio.
COAXIAL
You can patch outputs to Bus Outs and Input Channel Direct Outs
(see page 114).
Advertisement
Table of Contents
